SiriusXM SXDV3

SiriusXM SXDV3 інструкція користувача

(1)
  • 2 3
    65
    7
    Find a Location for the Vehicle Dock and Mount it
    Select either the Dash Mount or the Vent Mount method for mounting the Vehicle Dock. You will need a phillips screwdriver to complete the installation.
    NOTE: Your Radio may be a different model than the Radio shown here.
    TIP! You can take advantage of the wire guide channel across the back of the Vehicle Dock to organize the wires which connect to the dock.
    You’ll need to insert the Radio Dock Adapter that is compatible with your Radio into the Vehicle Dock.
    A. Locate the Radio Dock Adapter that is compatible with your Radio.
    If you have an XM or SiriusXM Radio: If your Radio is branded as XM* or SiriusXM*, select the
    Radio Dock Adapter marked XM & SIRIUSXM on the back of the adapter.
    If you have a Sirius Radio: If your Radio is branded as Sirius*, select the Radio Dock Adapter
    that is marked SIRIUS on the back of the adapter.
    B. Orient and place the Radio Dock Adapter that you selected into the Vehicle Dock. Be sure the
    adapter is centered, and is seated all the way down into the dock.
    C. Once the adapter is seated correctly in the Vehicle Dock, gently press the top of the adapter
    against the dock with your finger until it clicks into place. The Radio Dock Adapter is now
    installed.
    Should it become necessary to remove the Radio Dock
    Adapter from the Vehicle Dock, use your fingernail to
    gently press down on the top of the adapter, and then use
    a long thin object such as a paper clip, a screw driver, or
    something similar to pry the adapter away until it releases
    from the dock. Then lift the adapter up and out of the
    dock.
    A. Mount the Magnetic Mount Antenna outside your vehicle, on a clean and dry horizontal surface
    that will always face the sky.
    B. Choose the location for the antenna according to your type of vehicle. Center it between the
    left and right sides, and away from other antennas.
    TIP: Use the Alcohol Prep Pad to clean the surface.
    Sedans and Coupes
    (above front windshield or rear window)
    Pickups
    (above front windshield)
    SUVs
    (rear of roof)
    Convertibles
    (leading edge of trunk)
    Mount the Magnetic Mount Antenna
    Start Here
    4
    Route the Antenna Cable
    NOTE: These instructions are for a sedan or coupe where the
    antenna is mounted above the front windshield. The SiriusXM
    Dock and Play Vehicle Kit User Guide SXDV3 has detailed antenna
    cable routing instructions for all types of vehicles.
    Go to
    www.siriusxm.com/guides for the User Guide.
    A. Tuck the antenna cable under the windshield rubber
    molding and run it to the nearest corner.
    B. Route the cable out of the molding and into the rubber
    weather stripping around the door opening.
    C. Lift the weather stripping. Tuck and run the cable inside it
    to the bottom of the door opening. Replace the weather stripping.
    D. Pull the cable out and route it to your Radio.
    E. Plug the Magnetic Mount Antenna connector into the silver ANT connector on the
    side the Vehicle Dock.
    TIP: Include enough slack in your routing to accommodate open doors or the hood lid. Coil any
    excess cable in a hidden location and keep it away from any vehicle pedals or controls.
    Radio
    Location
    Dash Mount Method:
    IMPORTANT: The air temperature needs to be at least 60°F to install the Dash Mount. If needed, turn on the
    heater in your vehicle.
    A. Select a flat surface for the Dash Mount with ample room for the Vehicle Dock and Radio. Avoid
    mounting on leather surfaces. Choose a location that doesn’t interfere with the driver’s vision or
    access to driving controls, one that won’t interfere with the deployment of airbags or other safety
    equipment, and makes your Radio easily accessible for operation. (Airbag locations are typically
    marked with “SRS” logos.)
    B. Orient the adhesive foot so that your Radio is easily accessible. Loosen the knob and adjust the
    adhesive foot to position 1, 2, or 3, and then tighten it.
    C. Attach the Dash Mount to the PowerConnect Vehicle Dock using
    the 4 provided screws. If you plan to use the wire guide channel
    across the back of the Vehicle Dock to organize the wires, do not
    fully tighten the screws. If not, tighten the screws.
    D. Clean the mounting surface in the vehicle with the alcohol
    preparation pad and let it dry thoroughly.
    E. Once the surface is dry, remove the adhesive liner. Press and hold
    the Dash Mount in place for 30 seconds. Allow the adhesive to
    cure for at least 2-4 hours.
    F. You can tilt the dock mounting plate in your preferred direction.
    (Note that for clarity the illustration does not show the Vehicle
    Dock attached to the Dash Mount.)
    jump
    FM
    menu
    2
    3
    4
    5
    6
    7
    8
    9
    0
    direct
    1
    1
    2
    3
    2
    3
    4
    5
    6
    7
    8
    9
    0
    direct
    jump
    FM
    menu
    1
    2
    3
    4
    5
    6
    7
    8
    9
    0
    direct
    jump
    FM
    menu
    1
    2
    3
    4
    5
    6
    7
    8
    9
    0
    direct
    jump
    FM
    menu
    1
    1
    2
    3
    4
    5
    6
    7
    8
    9
    0
    direct
    jump
    FM
    menu
    1
    jump
    FM
    menu
    2
    3
    4
    5
    6
    7
    8
    9
    0
    direct
    1
    Vent Mount Method:
    A. Select a vent with ample room for the Vehicle Dock and Radio, one that won’t interfere with the deployment
    of airbags or other safety equipment, and makes your Radio easily accessible for operation. (Airbag locations
    are typically marked with “SRS” logos.)
    B. Some vents have recessed louvers. If yours are recessed, remove the regular vent clamps and install the
    extended vent clamps.
    C. Attach the Vent Mount to the PowerConnect Vehicle Dock using the 4
    provided screws. If you plan to use the wire guide channel across the
    back of the Vehicle Dock to organize the wires, do not fully tighten
    the screws. If not, tighten the screws.
    D. Install the Vent Mount onto the vehicle vent. (Note that for clarity the
    illustrations below do not show the Vehicle Dock attached to the Vent
    Mount.)
    i. Insert the vent mount into the vent opening.
    ii. Push until hooked on the rear of the vent louver. Rest the foot
    against the bottom of the vent.
    iii. If necessary, adjust the tilt of the Vent Mount by repositioning the foot to a different tilt adjustment
    hole.
    PUSH
    III III
    Dash
    Dash
    Dash
    Vent
    Louver
    Vent
    Vent
    HOOKED
    TILT
    ADJUSTMENT
    HOLES
    FO OT
    Knob Adhesive Foot
    Option 1 Option 2 Option 3
    Dock Mounting Plate
    Round End Orientation
    Ve
    nt Mount Rear View
    Slide Left Clamp
    to
    Hole in Center
    Pull Clamp Out
    Towards Yo u
    Insert Round End
    of the Extended
    Clamp in the
    Center Hole
    Slide Clamp to Left
    to Complete
    Installation
    Repeat to Replace
    Right Clamp
    Insert the Radio Dock Adapter Into the Dock
    1
    SIRIUS
    Front View
    Correct
    Orientation
    Back
    View
    XM & SIRIUSXM
    Front View
    Correct
    Orientation
    Back
    View
    AUDIO
    ANT
    *If you are unsure whether your Radio is an XM, SiriusXM,
    or Sirius Radio, check the label on the back of the Radio. If
    the label on your Radio says XM Radio ID or Radio ID, and
    has an 8-digit alphanumeric number, it is an XM or SiriusXM
    Radio. If the label on your Radio says Sirius ID, SID, or ESN,
    and has a 12-digit numeric number, it is a Sirius Radio.
SiriusXM SXDV3

У вас виникло питання стосовно SiriusXM SXDV3?

Кількість запитань: 0

Задайте запитання іншим користувачам SiriusXM SXDV3. Надайте чіткий та вичерпний опис проблеми та свого запитання. Чим детальнішим буде опис проблеми/запитання, тим легше буде іншим користувачам SiriusXM SXDV3 надати вам вичерпну відповідь.

Ознайомтеся з безкоштовною інструкцією для SiriusXM SXDV3. Ви ознайомились з інструкцією, але не змогли знайти відповідь на своє запитання? В такому випадку задайте своє запитання іншим користувачам продукції SiriusXM SXDV3 на цій сторінці. Введіть ваше запитання тут

Характеристики продукту

Загальна інформація
Бренд SiriusXM
Модель SXDV3
Продукт Радіопристрій
Мова Англійська
Тип файлу PDF

інструкціїкористувача.com.ua

Шукаєте інструкцію? інструкціїкористувача.com.ua гарантує, що ви знайдете необхідне за лічені секунди. У нашій базі міститься більше 1 мільйона PDF-інструкцій від більш ніж 10 000 торгових марок. Щодня ми додаємо нові версії інструкцій, аби ви завжди могли знайти необхідну саме вам. Усе дуже просто: просто вкажіть назву торгової марки та тип продукції в рядку пошуку, i ви зможете безкоштовно та миттєво переглянути необхідну інструкцію.

інструкціїкористувача.com.ua

© Copyright 2020 інструкціїкористувача.com.ua. Усі права захищено.