Sony SS-V521

Sony SS-V521 інструкція користувача

(1)
  • Ee
    SURROUND BACK
    Ee
    English
    Hooking up the speaker (A)
    Connect the speaker to the speaker output terminals of
    an amplifier.
    Make sure power to all components (included the
    subwoofer) is turned off before starting the hook-up.
    Notes (B)
    Make sure the plus (+) and the minus (–) terminals on
    the speakers are matched to the corresponding plus (+)
    and minus (–) terminals on the amplifier.
    Be sure to tighten the screws of the speaker terminals
    securely as loose screws may become a source of noise.
    Make sure all connections are firm. Contact between
    bare speaker wires at the speaker terminals may cause
    a short-circuit.
    For details regarding the connections on the amplifier
    side, refer to the manual that was provided with your
    amplifier.
    Tip
    All striped wires are minus (–) in polarity, and should be
    connected to the minus (–) speaker terminals.
    A
    E
    e
    E
    e
    E
    e
    E
    e
    B
    Micro Satellite Speaker
    SS-V811ED/V521
    Surround back
    Foot pads
    D
    1342
    C
    2001 Sony Corporation Printed in China
    Specifications
    SS-V811ED (SS-MS815)
    Speaker system 2 way, magnetically
    shielded
    Speaker units Tweeter: 1.9 cm (
    3
    /
    4
    in.),
    dome type
    Woofer: 5 cm (2 in.) × 2,
    balanced drive type
    Enclosure type Bass reflex
    Rated impedance 8 ohms
    Power handling capacity
    Maximum input power: 140 W
    Sensitivity level 87 dB (1 W, 1 m)
    Frequency range 120 Hz - 70,000 Hz
    Dimensions (w/h/d)
    When attached speaker grille:
    Approx. 86 × 169 × 130
    mm
    (3
    1
    /
    2
    × 6
    3
    /
    4
    × 5
    1
    /
    8
    in.)
    When attached to supplied speaker stand:
    Approx. 96 × 207 × 141
    mm
    (3
    7
    /
    8
    × 8
    1
    /
    4
    × 5
    5
    /
    8
    in.)
    Mass
    When attached speaker grille:
    Approx. 1.3 kg
    (2 lb 14 oz)
    When attached to supplied speaker stand:
    Approx. 1.4 kg
    (3 lb 1 oz)
    SS-V521 (SS-MS525)
    Speaker system Full range × 2,
    magnetically shielded
    Speaker units 5 cm (2 in.), balance
    drive type
    Enclosure type Bass reflex
    Rated impedance 8 ohms
    Power handling capacity
    Maximum input power: 120 watts
    Sensitivity level 87 dB (1 W, 1 m)
    Frequency range 120 Hz - 20,000 Hz
    Dimensions (w/h/d) Approx. 89 × 144 ×
    130 mm
    (3
    5
    /
    8
    × 5
    3
    /
    4
    × 5
    1
    /
    8
    in.),
    including front grille
    Mass Approx. 750 g
    (1 lb 10 oz)
    Positioning the speakers
    Location of each speaker
    Tips
    Movies are best enjoyed in a room that produces no
    echoes (as in one with surrounding curtains).
    Music (especially classical music) is best enjoyed in a
    room that produces some echo.
    Positioning the speaker
    (for SS-V811ED only) (
    C)
    Attach the speaker to supplied speaker stand and place
    them at their optimum locations.
    For details on the location of the speaker, see “Location
    of each speaker”.
    1 Detach the plate from the stand.
    2 Pass the speaker cord into the hole on the
    back of the stand and out from the hole at the
    center of the stand.
    3 Separate the speaker cord, then secure the
    cord to the speaker stand with the plate.
    4 Connect the speaker cord to the speaker
    terminal.
    The cord should be pressed into the groove
    in the stand.
    5 Using the supplied screws and washers,
    secure the speaker to the stand.
    Note
    Do not remove the supplied speaker grille from the
    speaker while attaching the speaker to the speaker stand.
    Setting the speaker
    (for SS-V521 only) (
    D)
    To prevent speaker vibration or movement while
    listening, attach the supplied foot pads to the speaker.
    Precautions
    On operation
    Do not drive the speaker system with a continuous
    wattage exceeding the maximum input power of the
    system.
    If the polarity of the speaker connections are not
    correct, the bass tones will be weak and the position of
    the various instruments obscure.
    Contact between bare speaker wires at the speaker
    terminals may result in a short-circuit.
    Before connecting, turn off the amplifier to avoid
    damaging the speaker system.
    If you encounter color irregularity on a
    nearby TV screen
    This speaker system is magnetically shielded to allow it
    to be installed near a TV set. However, color
    irregularities may still be observed on certain types of TV
    sets.
    If color irregularity is observed...
    c Turn off the TV set once, then turn it on again after
    15 to 30 minutes.
    If color irregularity is observed again...
    c Place the speakers further away from the TV set.
    If howling occurs
    Reposition the speakers or turn down the volume on the
    amplifier.
    On placement
    Do not set the speakers in an inclined position.
    Do not place the speakers in locations that are:
    Extremely hot or cold
    Dusty or dirty
    Very humid
    Subject to vibrations
    Subject to direct sunlight
    On cleaning
    Clean the speaker cabinets with a soft cloth lightly
    moistened with a mild detergent solution or water. Do
    not use any type of abrasive pad, scouring powder or
    solvent such as alcohol or benzine.
    If you have any questions or problems concerning your
    speaker system, please consult your nearest Sony dealer.
    Amplifier
    4-233-678-11(1)
    Front (Right)
    Subwoofer
    Rear(Right)
    Front (Left)
    Rear (Left)
    Center
    Surround back
    5
    Features
    The instructions in this manual are for SS-V811ED and
    SS-V521, Sony Micro Satellite Speaker.
    If you add this speaker to SA-VE815ED and SA-VE525,
    you can enjoy the surround effect as a 6.1 channel
    speaker system. Please refer to the manual provided for
    SA-VE815ED and SA-VE525 when you connect this
    speaker to the other speakers of SA-VE815ED and SA-
    VE525.
    Any difference in operation is clearly indicated in the
    text, for example, “SS-V811ED only”.
    Supplied accessories
    Speaker stand (1) (SS-V811ED only)
    Screws (2) (SS-V811ED only)
    Washers (2) (SS-V811ED only)
    Plate (1) (SS-V811ED only)
    Foot pads (4) (SS-V521 only)
    Speaker connecting cords, 10 m (32 ft 9
    3
    /
    4
    in.) (1)
    Design and specifications are subject to change without
    notice.
Sony SS-V521

У вас виникло питання стосовно Sony SS-V521?

Кількість запитань: 0

Задайте запитання іншим користувачам Sony SS-V521. Надайте чіткий та вичерпний опис проблеми та свого запитання. Чим детальнішим буде опис проблеми/запитання, тим легше буде іншим користувачам Sony SS-V521 надати вам вичерпну відповідь.

Ознайомтеся з безкоштовною інструкцією для Sony SS-V521. Ви ознайомились з інструкцією, але не змогли знайти відповідь на своє запитання? В такому випадку задайте своє запитання іншим користувачам продукції Sony SS-V521 на цій сторінці. Введіть ваше запитання тут

Характеристики продукту

Загальна інформація
Бренд Sony
Модель SS-V521
Продукт Динамік
Мова Англійська, Французький
Тип файлу PDF

інструкціїкористувача.com.ua

Шукаєте інструкцію? інструкціїкористувача.com.ua гарантує, що ви знайдете необхідне за лічені секунди. У нашій базі міститься більше 1 мільйона PDF-інструкцій від більш ніж 10 000 торгових марок. Щодня ми додаємо нові версії інструкцій, аби ви завжди могли знайти необхідну саме вам. Усе дуже просто: просто вкажіть назву торгової марки та тип продукції в рядку пошуку, i ви зможете безкоштовно та миттєво переглянути необхідну інструкцію.

інструкціїкористувача.com.ua

© Copyright 2020 інструкціїкористувача.com.ua. Усі права захищено.